Congratulations! You've got your Woojer Vest Edge!

Please read the following instructions carefully before the first use of your Vest. 

For detailed information about various connections (PC, gaming consoles, mobile, VR, TV & Home Cinema), please refer to the Woojer Vest Edge section on our support portal.


Charging the Vest

Connect the provided charger to the Vest's charging port. Before first use, charge your Vest Edge for two hours. When fully charged, you'll see the solid green LED.


Note: The USB-C port can be used for charging, as long as you use a USB-C Power Delivery 20V/5A wall charger.

Charging the Vest using the provided charger

Charging the Vest using a USB-C Power Delivery 10V/5A charger

Connecting the Vest

You can connect your Vest to a media source, using one of the following:

  • Bluetooth connection. To enter pairing mode, press and hold the Power button for 5 seconds. The blue and red LEDs will blink alternately. On your device, locate and pair with Woojer Vest Edge.
  • USB-C cable
  • 3.5mm cable

Wearing the Vest

All adjusting straps must be loosened before wearing the Vest Edge.

Make sure to follow these three steps by their order.

  1. Close and tighten the waist straps.
  2. Close and tighten the chest strap.
  3. Pull both shoulder straps in parallel to ensure a tight contact of all haptic units to the body.

Using your Vest

  • Turn on the Vest by pressing the Power button for two seconds.

  • Connect your headphones to the headphone jack.

  • Turn on your audio source and enjoy the moment!


Maximize your experience

Set your audio source volume level to max, as this makes sure you get the maximized haptic effect. Then, to control the headphones volume level and sensation level, use the Strap's control buttons.


Calibrate your Woojer to your personal optimal settings.

Once calibrated, you must try out this Woojer Edge introduction demo.
We've also created some playlists for you to get the hang of Woojering: