Follow these steps to connect your Strap Edge to your receiver/amplifier. There are several options to connect the Strap to your receiver/amplifier. You can choose between a wired connection with an aux cable using the receiver/amplifier integral Bluetooth or using an external Bluetooth transmitter. 


When using Bluetooth, remember that once completing the pairing process,  the Strap will automatically remain connected when turned on. 


Important: Always set your system volume to high/max, to ensure maximum effect. To control the headphones and sensation levels - use the Strap's control buttons.



Option 1: Using an aux cable connected to the receiver/amplifier

  1. Press and hold the Strap's power button for 2 seconds until the Strap turns on. 

  2. Connect the provided 3.5mm aux cable - one end to the receiver/amplifier line-out jack and the other to the Strap’s audio input jack. The blue LED will appear constantly.

  3. Connect your headphone to the Strap’s headphone jack.





Option 2: Using receiver/amplifier integral Bluetooth connection

  1. Enter pairing mode by pressing the Strap's Power button for 5 seconds. The blue and red LEDs will blink alternately.

  2. On your receiver/amplifier, enter pairing mode and locate Woojer Strap Edge

  3. Pair and connect the Strap with your receiver/amplifier. The blue LED will illuminate constantly.

  4. Connect your headphone to the Strap's headphone jack.





Option 3: Using an external Bluetooth transmitter

  1. For this type of connection, you will need an external Bluetooth transmitter. 

  2. Connect the transmitter to your receiver/amplifier by using either a 3.5mm cable or by using a digital audio cable (S/PDIF)

  3. Pair your Strap with the Bluetooth transmitter: Enter pairing mode by pressing the Strap's Power button for 5 seconds. The blue and red LEDs will blink alternately. Refer to the transmitter manual for detailed pairing information.

  4. Connecting your headphones: You can connect wired headphones directly to your Strap. Alternatively, if your Bluetooth transmitter is a dual-link one, you can pair both the Strap and your Bluetooth headphones, concurrently. 

  5. If your Bluetooth transmitter is a dual-link one, you can pair two Strap units at the same time. In this case, connect each one of them to wired headphones. 




Here are some examples of low-latency Bluetooth transmitters:

Avantree low-latency, dual-link Bluetooth transmitter, with S/PDIF input

Auxiliary aptX low-latency transmitter (dual-link)